about 5pcs IC I2C can not ACK from BQ27426,It get ACK OK after I2C add 1M pull down resistor,we test I2C sequency and it is OK. For normal operation, it is necessary to use the recommend 10k-Ω pull up ...

And there have one thing need your support! Below is customer analog to digital transform module block diagram, customer want to know could 953 receive MIPI from Analog video input As long as the MIPI ...

we have a microelectronic system which draws power from the REG1 configured to supply 3.3V when the battery pack is connected. However, when the battery pack is not connected, we will supply 3.3V from ...

On the frontpage of the data sheet is a simplified schamatic which shows two resistor at OSCinP and OSCinM to ground. But if I check on page 61 (Figure51. TypicalApplicationSchematic), there is a 100 ...

The following two ISRs have different PIEACK clearing methods. Writes of 0 are ignored in PIEACK registers and hence both the methods are doing the job. Method 2 is better as method 1 is doing ...

How do you run the flash frequency test in CCS v4? In "F28335 Flash Settings", I can set the clock configuration and GPIO, but there is nothing there to let me perform the frequency test.